Study of the yoke for a 10m class telescope

Bibcode
2006SPIE.6273E..94C
DOI
10.1117/12.671816
Cavaller, Lluís; Siegel, Benjamin; Marrero, Juan; Villegas, Alejandro
Bibliographical reference

Optomechanical Technologies for Astronomy. Edited by Atad-Ettedgui, Eli; Antebi, Joseph; Lemke, Dietrich. Proceedings of the SPIE, Volume 6273, pp. 627331 (2006).

Advertised on:
7
2006
Number of authors
4
IAC number of authors
4
Citations
0
Refereed citations
0
Description
The yoke of an alt-az telescope should provide a stiff interface between the azimuth journal and the tube of the telescope. The stiffness of the yoke affects the performance of the telescope servosystem and its mass has an important contribution on the total weight of the telescope. Based on the design of the yoke of the GTC 10m telescope, a new configuration is analyzed in order to take advantage of the azimuth journal to increase the stiffness and reduce the weight of the yoke. The performance of this configuration is compared to that of the yoke of GTC.
Type
Non-refereed

It may interest you

  • Non-refereed
    Study of basaltic asteroids through their phase curves
    Introduction Classified as type-V, the basaltic asteroids of the Main Belt (MB), for the most part, are connected to Vesta's dynamic family. However, since the discovery of the V-type asteroid (1459) Magnya in the outer MB, several new asteroids have been found in different regions, including V-types from inner regions not belonging to the Vesta
    Arcoverde, Plicida et al.

    Advertised on:

    9
    2024
    Bibcode
    2024EPSC...17..999A
    Citations
    0
  • Non-refereed
    The Gravitational-wave Optical Transient Observer (GOTO)
    The Gravitational-wave Optical Transient Observer (GOTO) is a project dedicated to identifying optical counterparts to gravitational-wave detections using a network of dedicated, wide-field telescopes. After almost a decade of design, construction, and commissioning work, the GOTO network is now fully operational with two antipodal sites: La Palma
    Dyer, Martin J. et al.

    Advertised on:

    8
    2024
    Bibcode
    2024SPIE13094E..1XD
    Citations
    1
  • Non-refereed
    Innovative solution for upgrading commercial bearings for use in cryogenic instruments
    Infrared instruments for astronomy require many bearings for motion that must move in cryogenic conditions. There are poor and expensive options for this, and the companies with qualified bearings only supply after a long time. To attend these constrains, the Instituto de Astrofísica de Canarias (IAC) started to develop a procedure to upgrade
    Luján, Alejandro et al.

    Advertised on:

    8
    2024
    Bibcode
    2024SPIE13100E..73L
    Citations
    0